This file is indexed.

/etc/shinken/shinken-specific/poller.cfg is in shinken-common 1.4-2.

This file is owned by root:root, with mode 0o644.

The actual contents of the file can be viewed below.

 1
 2
 3
 4
 5
 6
 7
 8
 9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
#===============================================================================
# POLLER (S1_Poller)
#===============================================================================
# Description: The poller is responsible for:
# - Active data acquisition
# - Local passive data acquisition
# http://www.shinken-monitoring.org/wiki/official/configuringshinken/configobjects/poller
#===============================================================================
define poller {
    poller_name     poller
    address         localhost
    port            7771

    ## Optional
    manage_sub_realms   0   ; Does it take jobs from schedulers of sub-Realms?
    min_workers         0   ; Starts with N processes (0 = 1 per CPU)
    max_workers         0   ; No more than N processes (0 = 1 per CPU)
    processes_by_worker 256 ; Each worker manages N checks
    polling_interval    1   ; Get jobs from schedulers each N minutes
    timeout             3   ; Ping timeout
    data_timeout        120 ; Data send timeout
    max_check_attempts  3   ; If ping fails N or more, then the node is dead
    check_interval      60  ; Ping node every N seconds

    ## Interesting modules that can be used:
    # - NrpeBooster     = Replaces the check_nrpe binary. Therefore it
    #                       enhances performances when there are lot of NRPE
    #                       calls.
    # - CommandFile     = Allow the poller to read a nagios.cmd named pipe.
    #                       This permits the use of distributed check_mk checks
    #                       should you desire it.
    # - SnmpBooster     = Snmp bulk polling module
    #modules     NrpeBooster, CommandFile
    modules     

    ## Advanced Features
    #passive         0       ; For DMZ monitoring, set to 1 so the connections
                            ; will be from scheduler -> poller.
    #poller_tags     None
    realm   All
}