/usr/share/doc/bacula-common/README is in bacula-common 9.0.6-1build1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 | Your best bet to get Bacula compiled and running is
to read the online manual at:
http://www.bacula.org
You will save yourself a lot of pain if you read
the manual -- it is online at the above site.
Barring reading the manual, you might try the
following:
To Configure it:
CFLAGS="-g -O2" \
./configure \
--sbindir=$HOME/bacula/bin \
--sysconfdir=$HOME/bacula/bin \
--with-pid-dir=$HOME/bacula/bin/working \
--with-subsys-dir=$HOME/bacula/bin/working \
--enable-smartalloc \
--with-mysql \
--with-working-dir=$HOME/bacula/bin/working \
--with-dump-email=your@address.com \
--with-job-email=your@address.com \
--with-smtp-host=localhost
Build Bacula:
make
If you are doing a port, there should be no errors. The most
likely source of errors will probably come in the src/stored
directory in time.c or dev.c. There may also be problems in
lib/signal.c as I currently pull in all Linux signals, some of
which may not be available on your system.
To create the database:
src/cats/make_bacula_tables
To install:
make install
To start it:
cd $HOME/bacula/bin
./bacula start
To start it (as a developer). This is not appropriate if you
are installing Bacula.
./startit
./console
To stop it:
./stopit
Well, it is all just a bit more complicated than that,
but you should have the idea.
Be sure you read the chapter about testing your tape drive!
Don't waste a lot of time setting up and running Bacula, if
your drive is not supported.
FreeBSD users, pay special attention to the Device configuration
parameters needed to deal with FreeBSD tape drivers.
License:
Please see the file LICENSE for the terms of the license.
|