/etc/freeradius/3.0/mods-available/smsotp is in freeradius-config 3.0.16+dfsg-1ubuntu3.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 | # -*- text -*-
#
# $Id: 3be32b85f56a84725fe1a6bf508e459dbe6c4e02 $
# SMS One-time Password system.
#
# This module will extend FreeRadius with a socks interface to create and
# validate One-Time-Passwords. The program for that creates the socket
# and interacts with this module is not included here.
#
# The module does not check the User-Password, this should be done with
# the "pap" module. See the example below.
#
# The module must be used in the "authorize" section to set
# Auth-Type properly. The first time through, the module is called
# in the "authenticate" section to authenticate the user password, and
# to send the challenge. The second time through, it authenticates
# the response to the challenge. e.g.:
#
# authorize {
# ...
# smsotp
# ...
# }
#
# authenticate {
# ...
# Auth-Type smsotp {
# pap
# smsotp
# }
#
# Auth-Type smsotp-reply {
# smsotp
# }
# ...
# }
#
smsotp {
# The location of the socket.
socket = "/var/run/smsotp_socket"
# Defines the challenge message that will be send to the
# NAS. Default is "Enter Mobile PIN" }
challenge_message = "Enter Mobile PIN:"
# Defines the Auth-Type section that is run for the response to
# the challenge. Default is "smsotp-reply".
challenge_type = "smsotp-reply"
# Control how many sockets are used to talk to the SMSOTPd
#
pool {
# Number of connections to start
start = 5
# Minimum number of connections to keep open
min = 4
# Maximum number of connections
#
# If these connections are all in use and a new one
# is requested, the request will NOT get a connection.
max = 10
# Spare connections to be left idle
#
# NOTE: Idle connections WILL be closed if "idle_timeout"
# is set.
spare = 3
# Number of uses before the connection is closed
#
# 0 means "infinite"
uses = 0
# The lifetime (in seconds) of the connection
lifetime = 0
# idle timeout (in seconds). A connection which is
# unused for this length of time will be closed.
idle_timeout = 60
# NOTE: All configuration settings are enforced. If a
# connection is closed because of "idle_timeout",
# "uses", or "lifetime", then the total number of
# connections MAY fall below "min". When that
# happens, it will open a new connection. It will
# also log a WARNING message.
#
# The solution is to either lower the "min" connections,
# or increase lifetime/idle_timeout.
}
}
|