/etc/dibbler/relay.conf is in dibbler-relay 1.0.1-1+b1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 | log-level 8
log-mode short
# Uncomment the following line to force relay to start including remote-id
# option with entreprise-id 5 and content of 01:02:03:04
# option remote-id 5-0x01020304
# Uncomment the following line to force relay to send Echo Request Option
# asking the server to echo back options 100, 101 and 102
# option echo-request 100,101,102
# Uncommenting this option will make relay to insert relay-id option
# into forwarded RELAY-FORW messages.
# option relay-id aa:bb:cc:dd:ee:ff
# Uncomment this line to tell relay to attempt to insert client link-layer
# address option. Relay will attempt to get that info from client's DUID
# or source IPv6 link-layer address. These are not 100% reliable methods!
# option link-layer
# The relay should listen on eth1 interface for incoming client's traffic.
# Clients by default send their traffic to multicast.
iface eth1 {
client multicast yes
# You may uncomment this if you want the relay to also listen on specific
# unicast address. Usually you don't need that.
# client unicast 2001:db8::1
# When forwarding traffic from that interface, please add interface-id
# with value 5555, so the server will know where the clients are connected.
interface-id 5555
}
# This is a second interface. It is used to reach the server.
iface eth2 {
# Send message on this interface to the server multicast (ff05::1:3)
server multicast yes
# send messages on this interface to this global address
# server unicast 2001:db8::123
}
|